Announcement

Collapse
No announcement yet.

Connecting multiple Robotinos to Robotino Factory

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Connecting multiple Robotinos to Robotino Factory

    Hi everyone!

    I am new to working with the Robotino and I am attempting to control a fleet of 3 Robotino 4 robots in Robotino Factory.

    To start with I am attempting to control 2 of 3 robots. I have managed to configure one of the routers to be a client and connect to the master Robotino. Once I have connected to the network of the master Robotino I can connect to the web interface of both Robotinos with the following IP addresses.

    Master Robotino: 192.168.0.1
    Slave Robotino: 192.168.0.2

    However, I am confused as to how to configure the SmartSoft settings in the Config tab. So far I have managed to connect either the master or slave Robotino to Robotino Factory by connecting to the IP 192.168.0.1 (master) but have not managed to get both to show up at the same time. The current configurations are as shown below (note: I have trying to change the slave IP to the slave Robotino which results in only the slave showing up)

    Master Robotino:

    Slave Robotino:


    Here is what my Robotino Factory looks like. As you can see only one robot is connected


    I would greatly appreciate any ​help with connecting multiple Robotinos to Robotino Factory! I also wanted to ask if there were any resources apart from the help manual where I can learn about how to use Robotino Factory.

    Thank you so much!
    Ash​​​

  • #2
    Hi, I can not see your configuration. Just empty boxes are displayed.

    Comment


    • #3
      Sorry about that. Hopefully these images are better.

      Master:
      Click image for larger version

Name:	master.png
Views:	85
Size:	115.8 KB
ID:	13022
      Slave:
      Click image for larger version

Name:	slave.png
Views:	83
Size:	110.2 KB
ID:	13023

      Thanks!
      Attached Files

      Comment


      • #4
        RobotinoName. Choose 10 on the master Robotino and 11 on the slave Robotino.

        Comment


        • #5
          Hi verbeek,

          Sorry for the delay. I only gained access to the Robotinos again today but changing the RobotinoName as you mentioned has worked! Thank you for the help!!

          I also wanted to ask if there was any way to run Robotino view programs via Robotino Factory. Also, what is the best resource to learn more about how to use Robotino Factory? Thanks!

          Ash

          Comment

          Working...
          X
          😀
          🥰
          🤢
          😎
          😡
          👍
          👎