Announcement

Collapse
No announcement yet.

Motor 4

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • shawqie_m
    started a topic Motor 4

    Motor 4

    Hello,

    I was wondering how might I able to connect my motor 4 port to motor dc. Because when I tried to connect it and gave a constant value to motor power input it did not work. Any solution for this trouble?

  • verbeek
    replied
    You could try to run Motor3 from the command line on Robotino

    sudo robtopic pub motor3_setpoint 10 100

    Leave a comment:


  • shawqie_m
    replied
    It is free.

    Leave a comment:


  • verbeek
    replied
    look at /etc/robotino/controld3.conf
    There is a section [motor3]
    what is the configuration in there?

    Leave a comment:


  • shawqie_m
    replied
    i use 3.1.5 firmware version

    Leave a comment:


  • shawqie_m
    replied
    thank you for your reply, sir. I checked the web interface but still no idea how to configure as forklift output. If you please would explain me the way how to configure as motor/forklift output.

    Leave a comment:


  • verbeek
    replied
    This should work. What is the configuration of Motor4? See web interface. Could be that it is configured as gripper output.

    Leave a comment:

Working...
X